Online Specials
Why JR Inkjet?
Instructions
Contact Us
Privacy Policy
Home
|
Refill Kits | Bulk Ink | Accessories | Faxable Order Form | Bulk Paper
Refilling Instructions
Hewlett Packard High Capacity Cartridges
(HP51626A, 51629A, 51633M, C6614)
DeskJet 400, 500, 510, 520, 540, 500C, 550C, 560C, 600, 610, 612, 660C, 670C, 690C, 694C, 695C
- Air pressure within the cartridge is regulated by an aerator (Aperture C) which must be sealed to prevent leakage during refilling. Use adhesive tape to seal this aperture.
- The cartridge is sealed by a plastic ball in Aperture B in the top. (New versions of this cartridge do not have this opening therefore a 3mm hole must be carefully made in the same position shown) This must be removed by pushing it into the cartridge using a pointed instrument (e.g. a ball point pen tip).
IMPORTANT The aperture in the center of the top (Aperture A, see diagram above) must NOT be pierced.
- Assemble the syringe and filling needle and fill with ink.
The cartridge should now be rested in an upright position on a pad of absorbent tissue (wad of kitchen roll) and filled with 40ml. of ink through Aperture B which must then be resealed using the plug supplied. Ink will now drip from the nozzles. Blot the nozzles with the tissue until ink stops dripping.
- Remove the tape over aperture C, and blot with tissue if necessary.
- Clean the syringe with water and dry for future use.
NOTE: Empty cartridges should be refilled immediately
Return to Index
|
|
